Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.
It is highly recommended to always use the most recent driver version available. Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.
What's New in This Release:
Fixed the problem that the hard disk on IDE-1 may not be detected by when "OnChip SATA" is set to RAID.
Fixed the problem that CAS latency can not be set manually when the CPU: DRAM is set to PSB800/5:4 or PSB800/3:2.
Remove some string in "PnP/PCI Configuration".
Fixed the problem that system will reboot instead of shutdown when the "Wake Up by Alarm" is enabled.
Fixed the problem that there will be some wording error when set "Time Alarm".
Fixed the problem that the system will shutdown if the fan speed is too low and the "Shutdown When CPU FAN Fail" is enabled.
Enhance USB card reader compatibility.
Add Pentium 4 Extreme Edition support.
Fixed HDD size detected as 136GB when 200/250/300 GB SATA drives are connected to SATA1 or SATA2 (ICH5 SATA channels)
Show the correct subsystem device ID of the USB 2.0 and IEEE 1394 controller. (IC7 only)
Fixed the problem that certain CD/DVD-ROM could not be correctly detected when there is a HDD drive attached on the same IDE cable.
BIOS compile date: 10/30/2003.